Kodak DCS 500 Series User Manual page 242

Symptom
The shutter does not
release.
" " blinks in the
bc
Top LCD panel.
The Frames
Remaining indicator
on the Back LCD
panel reads 0.
The battery icon on
the back LCD panel
shows that the battery
is low.
Exposed a burst of
images and the Card
icon continues to
flash.
B-2
Cause
The Main switch is set to
L ).
(
The subject is not
focused. (The in-focus
indicator is blinking in
the viewfinder.
The PC Card is full
No PC Card in camera
The camera has
undergone some type of
malfunction.
The PC Card is full
Battery is low
It takes time to save a
burst of images.
Remedy
Set the Main switch to
(A)
Press the Shutter button
again halfway. If the
subject still cannot be
focused, refer to
"Difficult Subjects for
Autofocus" in Chapter 8.
Replace the PC Card or
delete some images
Insert a PC Card
Remove the battery from
the camera and reload it.
If the blinking " "
bc
indicator disappears, the
camera will operate
normally.
If the " " indicator
bc
does not stop blinking
after repeating the above
operation several times,
there is a malfunction in
the camera. Take the
camera to your service
representative.
Insert a different PC
Card or delete some
images from the PC
Card.
Recharge the battery,
replace it with a freshly
charged battery, or, if
working indoors, connect
the AC adaptor.
Wait a few seconds.