Configuring Photo Print Settings - Kodak ESP 7 User Manual

Viewing and Printing Photos

Configuring photo print settings

38
Most memory cards will work with this printer. When you insert a memory card, or
connect a camera or portable flash drive to the printer, the last photo taken is
displayed first.
CAUTION:
Do not insert more than one device, such as a USB thumb drive or memory
card, into the printer at a time, or you will get an error message. Also, never
remove or disconnect a memory card from its slot unless the blue light near
the slot is not blinking.
NOTE: Photos stored on a PictBridge camera are displayed on the camera's LCD
screen only. See
needed.
You can change the factory default print settings for your printer using the control
panel. Windows users may adjust some settings using Home Center software (see
Home Center Help, discussed in
using Home Center).
1. Insert a memory card into the appropriate slot, or plug a USB flash drive or
(PTP) digital camera to the front panel USB port. The last photo is displayed
first.
2. From the control panel, press Menu .
3. Press until the option you want to configure is selected, and then press OK .
4. As needed, press
5. Press OK to save the setting for the current print job.
6. To save the setting as the default value, select Save as Default and press OK .
7. As needed, press
and then press OK to return to viewing and selecting photos for printing. Or,
press Start to print the selected photo(s) with the selected settings.
www.kodak.com/go/aiosupport
Printing photos from a PictBridge camera, page
Home Center Software, page
or to change the setting.
or until View Photos is selected in the Print Photos menu,
40, as
17, for information on