Page 1
Networking Setup Guide Guide de configuration réseau Guía de configuración de red Guia de configuração de rede All-in-One Printers • Imprimantes tout-en-un Impresoras multifunción • Impressoras Multifuncionais...
NOTE: • You can change your connection type later. See the chapter Extended User Guide. • For additional networking information or troubleshooting, go to www.kodak.com/go/inkjetnetworking. Wireless (Wi-Fi) connection To connect your printer to a wireless network, see Connection, page Ethernet connection...
Before you connect You need to: • Have a functional 802.11 wireless network. Kodak recommends that you use a wireless access point, most commonly a router, that uses Dynamic Host Configuration Protocol (DHCP). • Determine whether your wireless router supports Wi-Fi Protected Setup (WPS).
If the printer is successfully connected, the Wi-Fi status light should be on. If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking. 7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to complete your setup.
1. Connect the Ethernet cable into the Ethernet port on the back of the printer. 2. Connect the other end of the Ethernet cable into an available Ethernet port on your router, switch, or hub. 3. Install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to complete your setup. www.kodak.com/go/aiosupport...