Configuring Your Printer; Configuring Printer Settings; Configuring Basic Printer Settings - Kodak ESP 3200 Series Start Here Manual

2

Configuring Your Printer

Configuring printer settings

Configuring basic
printer settings
4
This chapter presumes that you have set up your printer and that you may or may
not have installed the printer software.
NOTE: When you first power on the printer, the printer automatically steps you
through the process of selecting the Language .
To set or change basic printer settings:
1. Press Home .
to select Printer Settings , then press OK .
2. Press
3. Press to select one of the following settings:
• Date and Time *
– Press OK , then press
Press or
• Time to Low Power
– Press to change the time to energy-saving low power (select from 1 to 4
hours in 0.5 hour increments). After the Time to Low Power, the printer
goes into a low-power mode.
• Tagged Images Printing (see
to select On or Off .
– Press
If you select On , when you are printing pictures, the printer LCD prompts
you to verify that you want to print pictures that were tagged (or marked)
using your camera. Different cameras use different terminology; KODAK
Digital Cameras use "marked" images; others use either tagged images or
DPOF.
• Language
– Press OK , press
• Reset All Settings (see
NOTE: Resetting factory defaults does not change the date and time, language, or
country/region.
4. Press Back .
* You can also synchronize the printer's date and time to your computer from Home
Center Settings under Tools in Home Center Software.
www.kodak.com/go/aiosupport
to select Year , Month , Day , Hour , or Minute .
to change the values; press OK when you are done.
Printing tagged pictures, page
to select a language, then press OK .
Resetting factory defaults, page
14)
34)