Changing The Printer Connection Type; For Windows - Kodak ESP 7 User Manual

Changing the printer connection type

For Windows

USB to Wi-Fi
USB to Ethernet
You can change the way you connect to your printer at any time.
To convert the USB connection from a PC to a wireless network connection:
1. Disconnect the printer from the computer.
2. Use the Windows Control Panel to delete the printer from you computer.
3. Configure the wireless network from the printer front panel. See
wireless network connection, page
4. Press Menu .
5. Press until Network Settings is selected, and then press OK .
6. Select View Network Configuration and confirm you have an IP address.
7. Run the KODAK Printer Network Setup Utility. This is located at Start > All
Programs > Kodak >Kodak Printer Network Setup Utility .
8. Select Connect via Network - Wireless / Wi-Fi , then click Next to proceed. The
printer should be detected and driver installations begin. If you have more than
one printer connected to your network, select the printer and then click Next .
9. After the driver installation completes, click Done to proceed.
10. The printer will be named KODAK ESP 7-XXXX, where XXXX is a number unique
to your printer.
To convert the USB connection from a PC to an Ethernet connection:
1. Disconnect the printer from the computer.
2. Use the Windows Control Panel to delete the printer from you computer.
3. Connect the printer to the network (LAN port on Router) with an Ethernet cable
4. Run the KODAK Printer Network Setup Utility. This is located at Start > All
Programs > Kodak >Kodak Printer Network Setup Utility .
5. Select Connect via Network - Ethernet cable then click Next to proceed. The
printer should be detected and driver installations begin. If you have more than
one printer connected to your network, select the printer and then click Next .
6. After the driver installation completes, click Done to proceed.
7. The printer will be named KODAK ESP 7-XXXX, where XXXX is a number unique
to your printer.
www.kodak.com/go/aiosupport
KODAK ESP 7 All-in-One Printer
22.
Configuring a
29