Removing A Vrm - Dell Precision Workstation 450 User Manual

Close the computer cover.
6
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
7
them on.

Removing a VRM

CAUTION: Before you perform this procedure, follow the safety
instructions in the
Remove the microprocessor airflow shroud (for the Dell Precision 650
1
computer, see "Microprocessor Airflow Shroud" or for the Dell
Precision 450 computer, see "").
Press the securing clips at each end of the connector outward
2
simultaneously until the VRM slightly pops out from the connector.
Grasp the VRM by its top corners, and ease it out of the connector.
3
If you are installing a new VRM, see "Installing a VRM."
4
If you are not installing a new VRM, continue with step 5.
Install the microprocessor airflow shroud (for the Dell Precision 650
5
computer, see "Microprocessor Airflow Shroud" or for the Dell
Precision 450 computer, see "").
Close the computer cover.
6
NOTICE: To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
7
them on.
System Information Guide
.
169