Dell Precision Workstation 450 User Manual page 127

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
6
The computer detects that the new memory does not match the existing
configuration information and generates the following message:
The amount of system memory has changed.
Strike the F1 key to continue, F2 to run the setup utility
Press <F2> to enter system setup and check the value for System Memory.
7
The computer should have changed the value of System Memory to reflect the newly
installed memory. Verify the new total. If it is correct, skip to step 10.
If the memory total is incorrect, turn off and disconnect your computer and devices
8
from electrical outlets.
Open the computer cover and check the installed memory modules to ensure that
9
they are seated properly in their sockets. Then repeat steps step 4 through step 7.
When the System Memory total is correct, press <Esc> to exit system setup.
10
Run the Dell Diagnostics to verify that the memory modules are operating properly.
11
113
Memor y