Table of Contents
Advertisement
The replaceable components in this chapter are Customer Replaceable Units (CRUs).
CAUTION:
Customers can replace only the Customer Replaceable Units (CRUs) following the safety precautions
and replacement procedures.
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Stand
Removing the stand
Prerequisites
Follow the procedure in
Before working inside your
CAUTION:
When servicing the computer, place it on an elevated, clean, and flat surface. Place the display flat
on the surface with the stand over the edge of the surface. It is recommended to remove the stand to avoid
accidental damage to the computer display when servicing.
Figure 13. Caution for stand
NOTE:
The following procedure is applicable for both Y stand and Isosceles stand.
NOTE:
For replacement of stand or stand hinges, the replacement kit is shipped with both stand and stand hinges. Both
components are replaced together. Refer to the procedure for
About this task
The following image indicates the location of the stand and provides a visual representation of the removal procedure.
42
Removing and installing Customer Replaceable Units (CRUs)
Removing and installing Customer
Replaceable Units (CRUs)
computer.
removing the stand
and
installing the
5
stand.
Advertisement
Table of Contents
