Dell Precision Workstation 450 User Manual page 208

194 So l vi n g Pro b l em s
D
I S K E T T E R E A D F A I L U R E
might be loose.
• If the drive access light turns on, try a different disk.
• See "Floppy drive problems" for troubleshooting suggestions.
D
I S K E T T E S U B S Y S T E M R E S E T F A I L E D
might be faulty. Run the Dell Diagnostics.
D
I S K E T T E W R I T E P R O T E C T E D
the write-protect notch to the open position.
D — No floppy disk is in the drive. Put a floppy disk in the
R I V E N O T R E A D Y
drive.
G A20 — One or more memory modules might be faulty or
A T E F A I L U R E
improperly seated.
• Reinstall the memory modules and, if necessary, replace them.
• See "Memory Problems" for additional troubleshooting suggestions.
G — The operating system is unable to carry out the
E N E R A L F A I L U R E
command. This message is usually followed by specific information—for
example, Printer out of paper. Take the appropriate action to resolve the
problem.
H -
A R D D I S K C O N F I G U R A T I O N E R R O R
H -
A R D D I S K C O N T R O L L E R F A I L U R E
H -
A R D D I S K D R I V E F A I L U R E
The hard drive failed initialization.
• Run the Dell Diagnostics.
• See "Hard drive problems" for troubleshooting suggestions.
I
N S E R T B O O T A B L E M E D I A
nonbootable floppy disk or CD. Insert a bootable floppy disk or CD.
I
N V A L I D C O N F I G U R A T I O N I N F O R M A T I O N
— The computer configuration information does not match the
P R O G R A M
hardware configuration. Enter system setup and correct the computer
configuration information.
— The floppy disk may be defective or a cable
— The floppy drive controller
— The floppy disk is write-protected. Slide
—
—
—
— The operating system is trying to boot to a
-
P L E A S E R U N
SETUP