Using The Out-Of-Band Ethernet Management Port To Boot 7210 From The Network - Alcatel-Lucent 7210 Installation Manual

Using the Out-of-Band Ethernet Management Port to Boot 7210 from the
Network
Follow the same procedure as used for a uplink port until the following prompt is
displayed. Use the following procedure to use the out-of-band ethernet management port
to boot 7210 from the network.
eth-mgmt Port Setting
--------------------
The eth-mgmt port is disabled for Boot Interface Management Press ENTER to proceed
with no eth-mgmt port settings. Or "enable" to enable the port for Boot Interface Man-
agement: enable
At the above prompt enter 'enable' as shown to enable the use of out-of-band ethernet management
port for boot.
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted decimal form with a network length.
example:
Enter eth-mgmt IP Address :
Enter the IP address and mask that the device should use (for example, 10.135.4.172/24).
Since the FTP server is on a different subnet, you will have to enter IP routing information using
the Out-of-Band Ethernet Management port to boot 7210 from the nework.
Network Configuration
---------------------
Boot Interface Management
-------------------------
You specified a network location for either the
software or the configuration file. You need to
configure either eth-mgmt or uplinkA or uplinkB ports.
You will be asked to configure the port number, IP address,
static routes, and VLAN Id in case of uplink ports.
You specified network locations which might require
static routes to reach. You will be asked to
enter static routes until all the locations become
reachable.
Static routes should be entered in the following format:
prefix/mask next-hop ip-address
example:
Would you like to add a static route? (yes/no) yes
Enter ip route:
Enter a static route to the FTP server's subnet (for example, 10.10.170.0/24 next-hop 10.135.4.1) at
the prompt.
7210 SAS-X Installation Guide
192.168.1.169/24
192.168.0.0/16 next-hop 192.168.1.254
Configuring the 7210 SAS-X
Page 51