Alcatel-Lucent 7210 Installation Manual page 52

Initializing the System and Downloading Software
The device then prompts the user to configure the uplinkA and uplinkB port. Since we intend to
use the ethernet management port at the following prompts disable the use of uplink ports as shown
below.
uplinkA Port Setting
Existing uplinkA port settings are:
uplinkA-port
uplinkA-address
uplinkA-vlan
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
uplinkB Port Setting
Existing uplinkB port settings are:
uplinkB-port
uplinkB-address
uplinkB-vlan
uplinkB port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
uplinkB port will be disabled for Boot Interface Management
New Settings
------------
primary-image
#eth-mgmt Port Settings:
no
eth-mgmt-address
eth-mgmt-route
eth-mgmt-route
eth-mgmt-autoneg
eth-mgmt-duplex
eth-mgmt-speed
#System Settings:
wait
persist
console-speed
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no): yes
Type yes and press Enter.
Page 52
--------------------
1/1/1
0
0
--------------------
1/1/2
0
0
ftp://*:*@10.10.170.22/./images/both.tim
eth-mgmt-disabled
10.135.25.97/24
10.135.0.0/16 next-hop 10.135.25.1
135.254.0.0/16 next-hop 10.135.25.1
full
100
3
off
115200
7210 SAS-X Installation Guide