Connecting To A Power Source; Connecting To Ac Power - Alcatel-Lucent 7210 Installation Manual

Installing Your Switch

Connecting to a Power Source

This switch supports both AC and DC power supply modules.
Notes:
accepts a single AC and single DC power supply.

Connecting to AC Power

In order to comply with the GR-1089 Lightning Criteria for Equipment Interfacing With AC
Notes:
Power Ports, an external Surge Protective Device (Perma Power Model # PXD309) is intended to be
used at the AC input of the router.
To connect the switch to a power source:
Step 1
Step 2
Step 3
Step 4
Step 5
Page 36
The switch is designed to accept up to two AC or two DC power supplies. The switch also
Verify that the external AC power supply has the following rating: 100-240VAC, 50/60
Hz, 4-2A.
Make sure the AC power module is installed and powered OFF before you plug the power
cable into the AC power source.
Check the power module LEDs as the switch is powered on to verify that the Input LED
indicating external power status is on, and that the Output LED indicating internal power
conversion is on. If not, recheck the power supply and power cable connections at the
supply source and at the power module.
A redundent AC power module may be hot swappable plugged in. However, for safety
precautions the main power cord should be connected after the AC power module is
installed.
If you have installed both primary and redundant power supply modules, verify that the
LEDs on both modules are lit as indicated in the preceding step.
7210 SAS-X Installation Guide