Installing Your Switch
Step 7
Notes: In a redundant DC configuration, when swapping the DC power supply, the power source
should be turned off (typically at the breaker panel). It should be turned on only after reinserting the
new DC power supply into the chassis.
Connecting to the Console Port
The RJ-45 serial port on the front panel is used to connect to the switch for out-of-band console
configuration. The on-board configuration program can be accessed from a terminal or a PC
running a terminal emulation program.
The pin assignments used to connect to the serial port are provided in
Table 10: Serial Cable Wiring
Page 38
If you have installed both a primary and redundant power supply module, verify that the
LEDs on both modules are lit as indicated in the preceding step.
RJ45
Pin
RTS
1
DTR
2
TXD
3
GND
4
GND
5
RXD
6
DSR
7
CTS
8
Usage
Used as defined. Should be connected
Not used. Should not be connected
Used as defined. Should be connected
Used as defined. Should be connected
Used as defined. Should be connected
Used as defined. Should be connected
Not used. Should not be connected
Used as defined. Should be connected
7210 SAS-X Installation Guide
Table
10.