Alcatel-Lucent 7210 Installation Manual page 48

Service access switch (sas-x)
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

Initializing the System and Downloading Software
Enter the software URL. (For example,
ftp://<user>:<password>@10.10.170.22/./images/both.tim)
Configuration File Location
---------------------------
Here are some examples
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
tftp://192.168.1.150/./config.cfg
No existing Config URL
Press Enter, or type 'none' for no Config URL.
Config File URL:
Enter the location of the configuration file or none since you are booting for the first time.
Boot Interface Management
-------------------------
You specified a network location for either the
software or the configuration file. You need to,
configure either uplinkA or uplinkB ports.
You will be asked to configure the port number, IP address,
static routes, and VLAN Id for uplink ports.
uplinkA Port Setting
--------------------
Existing uplinkA port settings are:
uplinkA-port
uplinkA-address
uplinkA-vlan
uplinkA port is configured for Boot Interface Management,
Press Enter to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Type edit.
Existing uplinkA port for Boot Interface Management is port 1/1/1.
Press Enter to keep it.
Enter the new uplinkA port number for Boot Interface Management:
Page 48
You must enter the location of configuration
file to be used by TiMOS. The file can be on
a Compact Flash device, or on the network.
1/1/1
0
0
7210 SAS-X Installation Guide

Advertisement

Table of Contents
loading

Table of Contents