Establishing Switch Connections
Console Connection
7210 SAS-D Installation Guide
Access your newly installed switch two ways:
•
"Console Connection" on page 69
•
"Telnet Connection" on page 70
To establish a console connection, you will need the following:
•
An ASCII terminal or a PC running terminal emulation software set to the
parameters shown in the table below
•
The included RJ-45 serial cable
Table 12: Console Configuration Parameter Values
Parameter
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
To establish a console connection:
Step 1
Connect the terminal to the console port on the front panel using the serial
cable.
Power on the terminal.
Step 2
Establish the connection by pressing the Enter key a few times on your
Step 3
terminal keyboard.
At the router prompt, enter the login and password.
Step 4
The default login is
The default password is
Value
115,200
8
None
1
None
.
admin
.
admin
Configuring the 7210 SAS-D
Page 69