Installing Sfps; Removing Sfps - Alcatel-Lucent 7210 SAS-D Installation Manual

Installation Preparation

Installing SFPs

To install an SFP transceiver:
Step 1
Step 2
Step 3

Removing SFPs

If you are removing an SFP, have a replacement SFP or slot plug, an anti-static mat, and a safety
cap for the SFP transceiver ready.
To remove an SFP:
Step 1
Step 2
Step 3
Step 4
Step 5
Page 50
Remove the SFP from its anti-static packaging.
Holding the SFP by its sides, slide the unit into the port until it clicks into place.
Remove the plug from the SFP optical bore when you are ready to attach the network
cable.
Disconnect the network cable from the optical connector.
Pull the lever located in the front of the SFP with your thumb and forefinger. Slide the
connector out of the port.
Place the SFP on an anti-static mat or in an electro-static bag.
Install an SFP replacement or re-insert the plug.
Connect the network cable or place a safety cap over the optical transceiver.
7210 SAS-D does not use a fan for cooling and the SFPs might be
Caution:
slightly hotter than usual. Avoid direct contact with the metal casing of the SFPs.
7210 SAS-D Installation Guide