Initializing the System and Downloading Software
Downloading the TiMOS software to the internal flash
Page 66
If you want to boot the SAS-D from the internal flash, you will have to copy the image
there.
If you have used the uplinkA or uplinkB port to boot the 7210, use any of the network
ports for IP connectivity and follow the procedure given below to configure an IP
interface and a route.
Change the mode of the connected port to 'access uplink'
A:SN12# configure port 1/1/10
A:SN12>config>port#
A:SN12>config>port# ethernet mode access uplink
A:SN12>config>port# no shutdown
A:SN12>config>port# exit
Configure an IES service.
A:SN12# configure service
A:SN12>config>service# info
----------------------------------------------
customer 1 create
description "Default customer"
exit
ies 2 customer 1 create
interface "in-band-mgmt" create
address 10.135.4.172/10
sap 1/1/10:0.* create
exit
exit
no shutdown
exit
----------------------------------------------
A:SN12>config>service#
7210 SAS-D Installation Guide