Programming The Command Timers - Silvercrest URC 101 DT Operation And Safety Notes

For the other three commands the following buttons
cannot be used: the source buttons (2), the navigation
buttons (13), the OK (12), MACRO (15), SETUP (17) and
EXIT (16) buttons.
You can set up to four command timers (Timer 1, Timer
2, Timer 3 and Timer 4).
When the timer function has been completed it will be
automatically deleted.

Programming the command timers

Example: The programming of a command timer will be
described below, to start recording on a DVD Recorder.
Hold down the setup button (17)
seconds until
Press the setup button (17)
up the
Press OK (12)
menu.
. The display will show the
menu.
is shown.
twice more to bring
for about 3
45