Maintenance - ECM ClassikaII Instruction Manual

6 Switch off the machine, remove and clean the water tank and fill it with fresh water.
7 Switch on the machine and release approx. 1,000 ml of water from the group and the steam/ hot water valve (switch
pump/ hot water).
8 Repeat this process approx. 4 times to make sure that no descaler is left in the boiler.
9 Operate the group lever 3 times for approx. 20 seconds. Move the lever into the lower position after every operation.
Thus, the expansion valve will be descaled. Then remove the blind filter from the filter holder.
Important!
These descaling instructions are only meant for prophylactic descaling. Please do not descale the machine
if it is already calcified only by the service-shop. While descaling the machine, the lime residues can plug
several components, like valves, gauges etc., causing damage to your espresso coffee machine. In this
case, please contact your specialised dealer. It is probable that a professional descaling has to be carried
out which requires the disassembling of boiler and tubing.
Damage to persons or to the material, caused by calcification in and at your machine, is not subject to the
producer's liability.
In this case, also the warranty expires. Machines will be only accepted for repair after foregoing
technical advice and written acknowledgement.
Please do not enclose loose parts e. g. filter holder or drip tray when sending in the machine for repairs /

maintenance.

7.4 Maintenance
(If you have any questions, please contact your specialised dealer.)
Replacing the group gasket and the net filter (Group gasket (item no. C449900229) and net filter (item no.
C519900103) must be changed at the same time)
1 Switch off the machine (power switch in lower position) and disconnect the power cord.
2 Open the steam valve and release the steam. Then close it again.
3 Let the machine cool down to ambient temperature.
Follow the steps as indicated below:
1
Brewing group in the beginning.
4
Remove the net filter and the gasket
completely.
Instruction manual CLASSIKA
2
Use a flat screwdriver to lever out the
net filter and the group gasket.
5
Keep the new spare parts ready at
hand (the chamfered side of the group
gasket with ECM print faced upwards
to the brewing group).
23
3
The net filter and the gasket are now
nearly removed.
6
Clean the group with a brush.
Lock the net filter firmly into the
gasket.
ENGLISH