Receiving An All Ships Call - Standard Horizon Eclipse GX1300 Owner's Manual

7. After the all ships call is transmitted, the trans-
ceiver will switch to the channel which select-
ed on the step 5 above, with no change of the
display. To change the display, press the
soft key.
8. Listen to the channel to make sure it is not busy, then key the micro-
phone and say "PAN PAN, PAN PAN, PAN PAN" or "Securite, Securite,
Securite" depending on the priority of the call. Say your call sign and
announce the channel you wish to switch to for communications.

9.4.2 Receiving an All Ships Call

1. When an all ships call is received, an emergency alarm sounds.
The display will show the MMSI (or name) of the vessel transmitting the
all ships call.
2. Press any key on the radio to stop the alarm.
3. To immediately switch to requested channel,
ACCEPT
press the
If a key is not pressed for thirty seconds (by
default; refer to the section "10.3.8 Auto
Channel Switching Time") after an all ships
call is received, the GX1300 will automatically
switch to the requested channel for you to
monitor communications.
P A U S E
4. Press the
acknowledgement.
R E S U M E
Press the
acknowledgement.
5. If you want the radio to stay on the channel you were on before receiv-
ing the all ships call, press the
6. Press the ▲ / ▼ keys to scroll the screen and
see the MMSI (or name) of the calling vessel,
category of the call and requested operating
channel.
QUIT
7. Press the
ing channel number of the requested channel.
8. Press the PTT switch on the microphone and talk to the calling vessel.
Page 44
soft key.
soft key to suspend the
soft key to resume the
QUIT
soft key to display the operat-
[ Transmitted ]
QUIT
ACCEPT
BUSY
25W
USA
ALL SHIPS PAUSE
soft key.
ABLE
ALL SHIPS
CATEG: SAFETY
SINCE: 00:05
QUIT
RX ALL SHIPS
YAESU
CATEG: SAFETY
CH: 08
SINCE: 00:05
PAUSE QUIT
08
MEM
RESUME QUIT
RX ALL SHIPS
YAESU
CATEG: SAFETY
CH: 08
SINCE: 00:08
UNABLE QUIT
GX1300
A
C