Setup In A Windows Environment - Sharp X-M200DK Installation Manual

2. SETUP IN A WINDOWS ENVIRONMENT

2-1. SETTING THE IP ADDRESS OF THE MACHINE
Before installing the printer driver, be sure to set the IP address of the
machine as explained in "System Settings" in the "Network Printer"
manual on the CD-ROM. Consult your network administrator for the
correct IP address, subnet mask, and default gateway to be entered. If
a DHCP server will automatically assign an IP address to the machine,
the following procedure is not necessary. (To check the IP address
assigned to the machine by DHCP, see "2-2. CHECKING THE IP
ADDRESS".)
Caution: If the machine is used in a DHCP environment, the machine's
IP address may change automatically. If this happens, printing
will no longer be possible. In this event, use a WINS server or
do not use the machine in a DHCP environment.
2-2. CHECKING THE IP ADDRESS
There are several settings where the IP address must be entered or
checked.
To check the IP address of the machine, hold down the status button on
the network expansion kit at least 2 seconds to print out a Printer Set-
ting List.
Status
button
Caution: How to reset the network expansion kit
To reset the network expansion kit, power on the machine
while holding down the status button on the network expansion
kit.
Network scanner destination information and scanning set-
tings will remain after the network expansion kit is reset, how-
ever, the network settings and network printer settings will
revert to the factory default settings.
MX-NB10 7 - 2