Sharp X-M200DK Installation Manual page 8

6) Check that two hooks of the developer unit is hooked on the toner
cartridge guide, and secure the toner cartridge guide to the
developing unit.
* Check that the DV seal is free from the developer. If developer is
attached to the DV seal, clean it.
* After supplying developer, do not tilt or shake the developer
cartridge.
7) Attach the developer cartridge to the main unit, and secure it with
the screw.
B.Toner cartridge installation
1) Remove the new toner cartridge from the bag. Grasp the cartridge
on both sides and shake it horizontally four or five times.
4 or 5 times
2) Insert the toner cartridge along the guides until it locks in place while
pushing the lock release lever
•If there is any dirt or dust on the toner cartridge, remove it before
installing the cartridge..
C. Set the toner density reference control level
1) With the front cover open, turn ON the machine power and enter
SIM25-02.
Note: When the machine is not in the simulation mode, if the front
cover is closed and the machine power is turned ON, toner
may be supplied from the toner cartridge to the developer
cartridge.
Under this state, the toner density reference control level
adjustment cannot be made properly.
Therefore, if the front cover is closed and the machine power
is turned ON with the machine not in the simulation mode,
dispose developer and supply new developer and adjust the
toner density reference level.
2) Close the front cabinet.
3) Press [START] key, and execute SIM25-02.
Note: It takes about 3 minutes to execute SIM25-02 completely.
During execution of this simulation, the front cover must not be
opened and the machine power must not be turned OFF.
hook
MX-M200D/MX-M160D/MX-M160 3 - 2
4. Removal and storage of fixing screw
1) Lift the knob and gently pull out the tray.
2) Hold the paper pressure plate and turn the fixing screw in the arrow
direction.
3) Store the fixing pin and the fixing screw in the tray.
•Store the fixing screw which was removed in the above procedure 2 and
the fixing screw which was removed in procedure 2 of 2.
•Removal of protective material and fixing screw in the storage place in
the tray.
fixing
pin
Screw