7 ] Mx-Nb10; Unpacking And Installation - Sharp X-M200DK Installation Manual

[7] MX-NB10

1. UNPACKING AND INSTALLATION

1-1. UNPACKING
1-2. PACKAGED GOODS
1-3. INSTALLATION PROCEDURE
Turn off the main switch of the main unit and remove the power
plug of the main unit from the outlet.
1) Cut out the cut-out portions from the rear cabinet.
1) Cut out three cut-out portions from the rear cabinet using a cutter or
the like.
2) Use a Phillips screwdriver or the like to open a hole.
Phillips screwdriver
2) Attach the network expansion kit.
Connect the connector of the network expansion kit to the connector of
the main unit and put excessive harness into the cut-out portion in the
main unit.
Engage the two pawls on the rear of the network expansion kit with the
cut-out portions of the main unit and network expansion kit using the
supplied screw (3 x 14).
3) Connect the USB cable and the network cable.
1) Attach the supplied cable clamp to the position shown in the illustra-
2) Connect the USB cable to the network expansion kit and the main
3) Connect the network cable.
3
Insert the power plug of the copier to the outlet, turn the main
switch of the copier to the "ON" position, and perform network set-
ting and installation of the software.
MX-NB10 7 - 1
Screw (M3x14)
Pawl
tion.
unit. At this time, reduce slack of the cable with the cable clamp as
shown in the illustration.
Connector
Pawl