Toshiba e-STUDIO 520 Printing Manual page 336

6 Printing from Macintosh
"Stapling and hole punching cannot be performed according to the type of the Finisher
installed and the destination setting.
When "Auto" is select at the Destination option, the paper might be delivered to a tray
which cannot carry out stapling or hole punching according to the setting of the equip-
ment.
"Exit Tray" is only available when no finisher is installed.
"Tray 1" and "Tray 2" can be selected when the Finisher or Saddle Stitch Finisher are
installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
This option cannot be selected if a hole punch unit is not installed.
3) Stapling
This sets whether a print job is stapled.
- Off — Select this to print without stapling.
336 Printing from Application on Mac OS 8.6 to 9.x