Toshiba e-STUDIO 520 Printing Manual page 312

6 Printing from Macintosh
1) Destination
This selects the destination tray.
- Exit Tray — Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
"Stapling and hole punching cannot be performed according to the type of the Finisher
installed and the destination setting.
When "Auto" is select at the Destination option, the paper might be delivered to a tray
which cannot carry out stapling or hole punching according to the setting of the equip-
ment.
"Exit Tray" is only available when no finisher is installed.
"Tray 1" and "Tray 2" can be selected when the Finisher, or Saddle Stitch Finisher are
installed.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
312 Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x