APPENDIX G
1.
Notes to RMCS user
1.1
Introduction
RMCS stands for the Remote Management Center System. The purpose of this system is to speed
up customer service and reduce maintenance costs.
1.2.
System Configuration of RMCS MODEL40
System configuration of RMCS Model 40 is shown below. PC, FAX Modem are needed for the system.
(1) PC
(2) FAX modem
(3) RS232C cable
(4) SYSTEM DISK
(5) FAX DISK
1.3
Required System
The RMCS (Remote Management Center System) for Win must be installed in the PC that has
Windows-OS installed in order to run maintenance works from a remote location by using the RMCS
for Win.
The PC system, in which the RMCS for Win is installed and executed for maintenance works, differs
depending on the operation system.
The following system configuration is required to use the RMCS for Win.
OS
CPU
Memory
Hard Disk
Monitor Resolution
Recommended
Fax Modem
41309401TH Rev.4
RMCS SYSTEM MANUAL (For Model 40)
: IBM PC or compatible PC with Windows95/98 or Windows NT4.0.
: Any FAX modem be accessed by a serial port of Windows system. To achieve
the good stability and performance, the FAX modem shown in Table-1 are
recommended, which has been tested during development.
: In case the FAX modem needs the cable to attach to the PC
: To install this system and FAX DISKs.
: FAX DISK corresponds to each FAX model. This software includes default
data and communication control program for the target model of FAX
machine.
Windows95
Windows98
(OSR2~)
Pentium 166MHz or higher
32MB or higher
20MB or higher of free space
640 dots × 480 dots or higher
U.S.Robotics 56k faxmodem - External Model #5686
WindowsNT4.0 with
Service Pack 4 or higher
Windows2000
525 /