Mercedes-Benz G-Class Operator's Manual page 317

Monitor Active Monitor Active display message is shown
instead of the tire pressure display. The tire
pressures are already being monitored.
i
If a spare wheel is mounted, the system
may continue to show the tire pressure of
the wheel that has been removed for a few
minutes. Observe that the displayed value
is not the same as the current tire pressure
of the emergency spare wheel.
Tire pressure monitor warning mes-
sages
If the tire pressure monitor detects a signifi-
cant pressure loss on one or more tires, a
warning message is shown in the multifunc-
tion display. A warning tone also sounds and
the tire pressure warning lamp lights up in the
instrument cluster.
Each tire that is affected by a significant loss
of pressure is highlighted in the pressure dis-
play.
If the Correct Tire Pressure Correct Tire Pressure
X
appears in the multifunction display, check
the tire pressure on all four wheels and cor-
rect it if necessary.
If the Check Check Tires Tires
X
multifunction display, the tire pressure in
one or more tires has dropped significantly
and the tires must be checked.
If the Tire Press. Warning Caution Tire Press. Warning Caution
X
Tire Malfunction Tire Malfunction
the multifunction display, the tire pressure
in one or more tires has dropped suddenly
and the tires must be checked.
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
message
message appears in the
message appears in
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar ( page 309).
Y
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 309).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock (
Press the = or ; button on the steer-
X
ing wheel to select the
Press the 9 or : button to select
X
Tire Pressure Tire Pressure.
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for the individual tires or
the Tire Tire pressure pressure will
after driving a few minutes after driving a few minutes
sage.
Press the : button.
X
The Use Current Pressures as New Use Current Pressures as New
Reference Values Reference Values
the multifunction display.
If you wish to confirm the restart:
Press the a button.
X
The Tire Press. Monitor Restarted Tire Press. Monitor Restarted
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
Tire pressure
page 133).
Y
Serv. Serv. menu.
will be be displayed displayed
mes-
message appears in
Z
315