Mercedes-Benz G-Class Operator's Manual page 272

Features
270
been installed in the garage door remote
control.
Align the antenna cable of the garage door
R
opener unit. This can improve signal trans-
mission.
Opening/closing the garage door
Indicator lamp
:
Transmitter buttons
; = ?
Garage door remote control
A
Transmitter button on the garage
B
door remote control
Once programmed, the integrated remote
control will assume the function of the garage
door system's remote control. Please also
read the operating instructions for the garage
door system.
Turn the SmartKey to position 2
X
( page 133) in the ignition lock.
Y
Press transmitter button ;, = or ? on
X
the integrated remote control in the rear-
view mirror that is programmed to operate
the garage door.
Garage door system with fixed code: indi-
cator lamp : lights up continuously.
Garage door system with rolling code: indi-
cator lamp : flashes briefly and then lights
up for approximately two seconds. This is
repeated for up to 20 seconds.
i The transmitter will transmit a signal for
as long as the transmitter button is being
pressed. The transmission will be halted
after a maximum of 20 seconds and indi-
cator lamp : will flash. Press the trans-
mitter button again, if necessary.
Clearing the remote control memory
Indicator lamp
:
Transmitter buttons
; = ?
Garage door remote control
A
Transmitter button on the garage
B
door remote control
Turn the SmartKey to position 2
X
( page 133) in the ignition lock.
Y
Press and hold transmitter buttons ;
X
and ? for approximately 20 seconds until
indicator lamp : flashes rapidly.
The memory is cleared.
i
Make sure that you clear the remote con-
trol memory before selling the vehicle.
Floormat on the driver's side
G WARNING
Objects in the driver's footwell can restrict the
pedal travel or obstruct a depressed pedal.
The operating and road safety of the vehicle is
jeopardized. There is a risk of an accident.
Make sure that all objects in the vehicle are
stowed correctly, and that they cannot enter
the driver's footwell. Install the floormats
securely and as specified in order to ensure
sufficient clearance for the pedals. Do not use
loose floormats and do not place floormats on
top of one another.