Cornering Light Function - Mercedes-Benz G-Class Operator's Manual

Exterior lighting
104
High-beam flasher
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
To switch on: turn the SmartKey in the
X
ignition lock to position 1 or 2 or start the
engine.
Pull the combination switch briefly in the
X
direction of arrow =.
Hazard warning lamps
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the corre-
sponding side of the vehicle will flash.
To switch off the hazard warning lamps:
X
press button :.
The hazard warning lamps automatically
switch on if:
an air bag is deployed or
R
the Emergency Tensioning Devices are trig-
R
gered, or
the vehicle decelerates rapidly from a
R
speed of above 45 mph (70 km/h) and
comes to a standstill
The hazard warning lamps switch on auto-
matically if an air bag or the Emergency Ten-
sioning Devices are triggered and the Smart-
Key is in position 1 in the ignition lock.
The hazard warning lamps switch off auto-
matically if the vehicle reaches a speed of
above 6 mph (10 km/h) again after a full
brake application.
i
The hazard warning lamps still operate if
the ignition is switched off.

Cornering light function

The cornering light function improves the illu-
mination of the road over a wide angle in the
direction you are turning, enabling better vis-
ibility in tight bends, for example. The corner-
ing light function can only be activated if the
low-beam headlamps are switched on and the
fog lamps are switched off.
Active: if you are driving at speeds below
25 mph (40 km/h) and switch on the turn
signal or turn the steering wheel.
Not active: if you are driving at speeds above
25 mph (40 km/h) or switch off the turn sig-