Lenovo ThinkStation P500 Hardware Maintenance Manual page 151

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.
Installing or replacing a 2.5-inch storage drive with a converter in the storage drive bay
Depending on your computer model, one of the following types of storage drive bracket is used in the
storage drive bay:
Figure 66. Two types of storage drive bracket
Note: This section illustrates only installing or replacing a 2.5-inch solid-state drive with a converter.
To install or replace a 2.5-inch storage drive with a converter in a type
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 111.
3. Locate the storage drive bay in which you want to install or replace a storage drive. See "Locating
internal drives" on page 38.
4. Depending on whether you are installing or replacing a 2.5-inch storage drive with a converter, do
one of the following:
• If you are installing a 2.5-inch storage drive with a converter, open the handles on both sides of the
storage drive bracket, and pull out the empty bracket.
• If you are replacing a 2.5-inch storage drive with a converter, open the handles on both sides of the
storage drive bracket, disconnect the cables from the converter, and pull out the bracket.
1 bracket, do the following:
.
Chapter 11 Installing or replacing hardware
143