2. Lift the clip on the side of the flex module upward and slide the flex module cover to the rear of the flex
module to remove the cover.
Figure 25. Removing the flex module cover
3. If you are replacing a 29-in-1 card reader, do the following:
a. Disconnect the card reader cable from the system board.
b. Pull the clip as shown to remove the card reader with the card reader retaining bracket from the
flex module.
Figure 26. Removing the card reader in the flex module
c. Flex the four clips on the sides of the card reader retaining bracket to remove the card reader from
the bracket.
Figure 27. Removing the card reader from the card reader retaining bracket
120
ThinkStation P500 and P700 Hardware Maintenance Manual