Lenovo ThinkStation P500 Hardware Maintenance Manual page 130

6. Position the flex module cover on the flex module so that the rail guides on the bottom of the flex module
cover engage the rails on the flex module. Then, push the cover to the front of the flex module until
it snaps into position.
Figure 30. Reinstalling the flex module cover
7. Connect the card reader cable to the USB 2.0 connector or card reader connector on the system board.
See "Locating parts on the system board" on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 183.
Installing or replacing an eSATA connector or IEEE 1394 connector in the flex module
To install or replace an eSATA connector or IEEE 1394 connector in the flex module, do the following:
1. Slide the flex module out of the front of the computer. See "Installing or replacing a device in the
optical drive bay" on page 114.
2. Lift the clip on the side of the flex module upward and slide the flex module cover to the rear of the flex
module to remove the cover.
Figure 31. Removing the flex module cover
3. If you are replacing an eSATA connector or IEEE 1394 connector, do the following:
a. Disconnect the eSATA connector or IEEE 1394 connector cable from the system board.
122
ThinkStation P500 and P700 Hardware Maintenance Manual