How To Set Up Protocols And Id Dip Switches - Samsung SPU-3750T User Manual

Installing Your Camera
Note!
* DVRs that can fully control a PTZ Dome via RS-422/485 are as follows
- 32Ch : SVR-3200
- 16Ch : SVR-1680/1660/1645/1650E/1640A
- 9Ch : SVR-960/945/950E
- 4Ch : SVR-440
* Samsung Techwin DVR products that can fully control a PTZ Dome via coaxial are as
follows
- 16Ch : SVR-1680C,SVR-1660C
- 9Ch : SVR-960C
* The following DVR models support only the Pan, Tilt, Zoom, and Focus functions of
the camera.
- 9Ch : SVR-940
- 4Ch : SVR-450,SVR-470
* Memo
MEMO
22
SPEED DOME CAMERA User's Manual
Installing Your Camera

How to Set Up Protocols and ID DIP Switches

You can control various settings of the camera system using the Communication and ID
DIP switches. Before installing the product, please set up the DIP switches according to
the installation environment.
1. Detach the camera frame from the install base, and place the bottom of the frame
toward you as shown in the picture below.
2. Set the switches according to your installation environment. For more detailed setup
information, please refer to the chart on the next page.
3. The camera may malfunction if the switches are not fully turned On/Off; please
double check the switches before finishing setup.
Communication Protocol DIP Switch(SW2)
SPEED DOME CAMERA
Camera ID DIP Switch(SW1)
23
User's Manual