LT 1806 Product Reference Guide: Maintenance and Specifications
What If...
Nothing happens when you follow the operating
instructions.
You Should
Check the system power.
•
Make sure the scanner is programmed for the terminal in use.
•
Make sure the controller is programmed to decode bar codes of the
•
symbology you are scanning.
Check for loose cable connections.
•
Make sure the symbol is not defaced.
•
Try scanning test symbols of the same code type.
•
Scanned data is incorrectly displayed on the terminal.
You Should
Make sure that the system was programmed for the correct keyboard
•
type.
Make sure that the CAPS LOCK key is off.
•
Note: If after performing these checks the symbol still
does not scan, contact your distributor or call the
Symbol Support Center
numbers listed in
at one of the telephone
About This
Manual.
3-2