Chapter 4. Programming The Lt 1806; Scanning Sequence Examples; Scanning Sequences - Symbol LT 1806 Product Reference Manual

Chapter 4
Programming the LT 1806
Before programming the scanner, follow the instructions in
Up the LT 1806.
If the default values suit your requirements, scan the SET DEFAULT bar code.
An LT 1806 is programmed for parameters other than default values by
scanning sequences of bar codes.
codes necessary to program the scanner for each parameter selection.

Scanning Sequences

A scanning sequence establishes a value for one parameter type. During a
scanning sequence, scan bar codes for a parameter type, a parameter value,
and ENTER. The Scanning Sequence Flowchart on page 4-3
process.

Scanning Sequence Examples

To program the scanner for all default settings except for two parameters,
DECODE UPC ONLY (NOT EAN) and INTERCHARACTER DELAY, first
scan the SET DEFAULT bar code. The default for DECODE UPC ONLY (NOT
EAN) is DISABLE; to ENABLE this, scan the three bar codes in the order listed
below:
SCAN
1. DECODE UPC ONLY (NOT EAN)
2. ENABLE
3. ENTER
After the last scan in a successful scanning sequence (ENTER), the warble
sound (i.e., hi/lo/hi/lo) indicates that the scanner has been successfully
programmed for the selected parameter. See
Chapter 5: Parameter Menus
YOU WILL HEAR . . .
Short high tone
Short high tone
Hi/Lo/Hi/Lo warble
Beeper Definitions on page
4-1
Chapter 1: Setting
contain all the bar
illustrates the
4-13.