Chapter 2
Scanning with the LT 1806
Scanning
Make sure the scanner is connected to the controller or portable data
•
terminal before you turn on the system.
Make sure the symbol you want to scan is within the LT 1806 scanning
•
range. (See
LT 1806 Decode Zone on page
If the scanner is in triggerless mode, simply bring the scanner to the bar
•
code. The scan beam is in a constant blinking state which becomes steady
when the scanner is decoding a bar code.
If the scanner is in triggered mode, bring the scanner to the bar code and
•
press the trigger. The scan beam (and red LED on the top of the scanner)
illuminates for approximately 1 second, or until a successful decode.
The scan beam must cross every bar and space on the symbol.
•
RIGHT
012345
When the symbol has been decoded, you hear a short, high-tone beep,
•
and the green decode LED lights.
2-2.)
2-1
WRONG
012345