LS 3070 Product Reference Guide: Scanning with the LS 3070
What If ...
Nothing happens when you follow the operating
instructions?
You should
Check that the power supply is attached to the base/charger.
•
Check for loose cable connections at the base/charger and host device.
•
Check the scanner's battery pack.
•
Make sure the device is programmed to read the type of bar code you
•
want to scan.
Check the symbol to make sure it is not defaced.
•
Try scanning similar symbols of the same code type.
•
Check that the gas tank is not exhausted.*
•
Make sure the scanner and base/charger have been successfully paired.
•
Be sure you're within the proper scanning and transmission range.
•
If you get frequent Transmit Errors (error beeps after decode):
Check that you are within scanning transmit range. (See
•
Transmission Range on page
Check that the scanner is successfully paired with the base/charger.
•
Check that the base/charger is powered up and that its cable connections
•
are secure.
Note: If after performing these checks the symbol still
* The gas tank limits the amount of time the laser remains on within a given
period to conform to the requirements of specific laser output classifications.
does not scan, contact your distributor or call the
Symbol Support Center. See
on page About-ii
3-4.)
Symbol Support Center
for the telephone number.
3-5
Scanning