Symbol LT 1806 Product Reference Manual page 25

LT 1806 Product Reference Guide: Programming the LT 1806
CLSI Editing
If selected, this parameter inserts a space after the 1st, 5th, and 10th characters
of a 14-character Codabar symbol. The symbol length does not include start
and stop characters.
NOTIS Editing
If selected, this option strips the start and stop characters from decoded
Codabar symbols.
Transmit Code ID Character
A code ID character identifies the code type of a scanned bar code. This may be
useful when the scanner is decoding more than one code type. In addition to
any single-character prefix already selected, the code ID character is appended
as a prefix to the decode. Code ID characters are: A = UPC-A, UPC-E, EAN-13,
or EAN-8; B = Code 39; C = Codabar; D = Code 128; E = Code 93;
F = Interleaved 2 of 5; G = Discrete 2 of 5 or Discrete 2 of 5 IATA;
K = UCC/EAN128.
Transmit "No Decode" Character
This feature gives you the option to transmit "NR" when a symbol does not
decode. Prefixes and suffixes enabled are appended around this character.
Note: This option is available in Triggered Mode only.
Decode UPC/EAN Supplementals
Select whether UPC/EAN is decoded with or without supplemental
characters, or whether the unit autodiscriminates between the two.
Supplementals are additionally appended characters, according to specific
code format conventions (e.g., UPC A+2, UPC E+2, EAN 8+5).
If UPC/EAN with supplemental characters is selected, UPC/EAN symbols
without supplemental characters won't be decoded. If UPC/EAN without
supplemental characters is selected and the scanner is presented with a UPC/
EAN plus supplemental symbol, the UPC/EAN is decoded and the
supplemental characters ignored. If autodiscrimination is chosen, the LT 1806
will, after additional processing to ensure a good decode, transmit either.
4-7