Green Tally - Sony PMW-TD300 Operating Instructions Manual

a 3D/2D
Indicates the 3D/2D setting. During playback,
"PLAY" is displayed after "3D" or "2D".
b Zoom position
Indicates the zoom position of the zoom lens in
the range from 0 to 99.
c Focus position
Indicates the focus position as the distance from
the lens surface to the subject in units of meters or
feet.
d Green tally
Lights when the camcorder is the following
states.
• MAINTENANCE >Camera Config >HD-SDI
Remote I/F is set to [G-Tally] in the setup menu
and a recording control signal is output from the
HD/SD SDI OUT connector.
e Media status
Displays the name of the currently active media
slot (A or B).
f Recording mode/operation status
Indicates the current recording mode/operation
status as follows.
Indication Meaning
zREC Recording in progress
STBY Standby for recording
zCACHE
Standby in Picture Cache mode
zINT REC Recording in progress in Interval
Recording mode
zINT STBY Standby for next recording in
Interval Recording mode
INT STBY Standby in Interval Recording
mode
zFRM REC Recording in progress in Frame
Recording mode
zFRM Standby for next recording in
STBY Frame Recording mode
FRM STBY Standby in Frame Recording mode
zS&Q REC Recording in progress in Slow &
Quick Motion mode
S&Q STBY Standby in Slow & Quick Motion
mode
zCALL
Being called from a connected
device
BREVIEW During recording review
34 Viewfinder Screen Display
The indicator flashes when OPERATION
z
>Format>3D/2D in the setup menu is set to 3D
and you are recording to either the left slots or
right slots only.
g Wireless receiver reception level
When a wireless receiver is installed in the
camcorder, "W" appears together with four
segment reception level indicators for each of the
channels (1 to 4) that can be used by the receiver.
The indications are as follows.
In normal situation: The number of white
segments indicates the strength of the signal
level.
Muting (for an analog receiver) or error rate
aggravation (for a digital receiver): The
number of gray segments indicates the
strength of the signal level.
Reception level over peak: "P" is displayed
instead of the indicators.
Tuner battery is low: The channel number and
indicator of the corresponding channel
1)
flash.
1) When an optional DWR-S01D is used
h Battery remaining/voltage capacity
The following is displayed depending on the type
of power source.
Type of power What is displayed
source
InfoLithium Remaining battery capacity icon
battery and remaining recording time
Anton Bauer Remaining battery capacity (%
battery indication)
Other type than Input voltage
above
i External power input
Appears when power is supplied from an external
power source connected to the DC IN connector.
j VF image type
Indicates the type of image that is displayed in the
viewfinder. You can change the image display
using the VF DISPLAY SELECT switch (see
page 21).
VF:L: Displays the left lens image, in color.
VF:R: Displays the right lens image, in color.
VF:L+R: Displays an overlay of the left lens
image and the right lens image, in color, by
calculating the average for each pixel.
1)