Green Tally - Sony PMW-500 Operation Manual

OPERATION >Super Impose in the setup menu
or with related switches are displayed at the top
and bottom of the screen.
Caution messages are indicated for three seconds
when you carry out operations to change
camcorder settings. Adjustment execution
messages are indicated while adjustments
proceed. When adjustments are finished,
messages showing the results of adjustments
appear for three seconds.
Not only these indications are displayed on the
viewfinder screen, but a menu setting enables
them to be output as video signals.
All items that can be displayed on the viewfinder
screen are shown below.
Top of viewfinder screen
a Extender settings
Indicates the setting of the digital extender
function (when optional CBK-HD02 SDI/
COMPOSITE Input and 50 Pin Interface is
installed) of this camcorder and the setting of the
lens extender.
EX: The lens extender is on.
08: The lens shrinker is on.
x2D: The digital extender function of this
camcorder is on.
Ex2D: The lens extender and the digital extender
function of this camcorder are both on.
Digital extender function can be turned on or off
by an assignable switch to which Digital Extender
is assigned.
Note
When slow & Quick motion is selected or the freeze mix
function is used, the digital extender cannot be turned on.
When the camcorder is in focus magnification (Focus
Mag) mode, turning on the digital extender cancels the
mode.
b Zoom position (when the lens is
mounted)
Indicates the zoom position of the zoom lens in
the range from 0 to 99.
c Focus position (when the serial lens is
mounted)
Indicates the focus position as distance to the
subject (in units of m).
d Green tally
Lights when the camcorder is the following
states.
• MAINTENANCE >Camera Config >HD-SDI
Remote I/F is set to [G-Tally] in the setup menu
and a recording control signal is output from the
HD/SD SDI OUT connector.
• When the Picture Cache mode is enabled
• Green tally signal received (when a camera
adaptor is mounted on the camcorder and a
camera extension unit is connected)
e Media status
Displays the name of the currently active media
slot (A or B).
f Special recording mode/operation
status
Indicates the current special recording mode/
operation status as follows.
Indication Meaning
Recording in progress
zREC
STBY When recording is on a break in
Clip Continuous Rec mode or
standby in other modes
CONT Standby for next recording in Clip
Continuous Rec mode
Standby in Picture Cache mode
zCACHE
zINT REC Recording in progress in Interval
Recording mode
zINT STBY Standby for next recording in
Interval Recording mode
INT STBY Standby in Interval Recording
mode
zFRM REC Recording in progress in Frame
Recording mode
Standby for next recording in
zFRM
STBY Frame Recording mode
FRM STBY Standby in Frame Recording mode
zS&Q REC Recording in progress in Slow &
Quick Motion mode
Locations and Functions of Parts and Controls
31