Sony PMW-TD300 Operating Instructions Manual page 147

Assignable switch setting Function
Zoom Tele/Wide
Zoom Wide/Tele
Manual Focus Assist
Focus Mag
Zebra
Lens RET
Shot Mark1
Shot Mark2
OK Mark
Color Temp SW 3200K
Color Temp SW 4300K
Color Temp SW 5600K
Color Temp SW 6300K
Electrical CC
CC5600K
Slot Select
Grid(VF)
Convergence
Assign the Zoom Tele function to ASSIGNABLE 4, and
assign the Zoom Wide function to ASSIGNABLE 5
(displayed only when <4> and <5> are set).
Assign the Zoom Wide function to ASSIGNABLE 4, and
assign the Zoom Tele function to ASSIGNABLE 5
(displayed only when <4> and <5> are set).
Turn the manual focus assist function on or off.
Turn the focus magnification function on or off.
Turn zebra display on or off.
During recording or playback: Write a shot mark.
In the other states: Conduct a recording review
(if playback is allowed).
Write Shot Mark1.
Write Shot Mark2.
Add or delete an OK mark.
Adjust the white balance with a 3200K preset value.
Adjust the white balance with a 4300K preset value.
Adjust the white balance with a 5600K preset value.
Adjust the white balance with a 6300K preset value.
Function that switches the electrical CC filter (3200K/
4300K/5600K/6300K) applied to white balance
adjustment values.
Each press of the switch or button switches in the order
3200Kt4300Kt5600Kt6300K.
These can also be applied from a menu (apply with
Electrical CC<A><B><C><D>).
Note
This function is not available when White Filter >ND
Filter C.Temp in the Maintenance menu is set to On.
If you set ND Filter C.Temp to On after assigning the
function, the assignable switch ceases to function.
Apply a 5600K electrical CC filter to white balance
adjustment values.
Switch memory card slot (A or B).
Turn the grid display in the viewfinder on or off.
Record the convergence point distance when
Convergence is assigned to the assignable switch, and set
the convergence point to the recorded distance when the
assignable switch is used.
You can record different convergence point distances in
multiple assignable switches.
When you press an assignable switch with the SHIFT
button held down, the current convergence point distance
will be recorded.
State when camcorder
is next powered on
—
—
Setting retained
Setting not retained
Setting not retained
—
—
—
—
Setting retained
Setting retained
Setting retained
Setting retained
Setting retained
Setting retained
—
Setting retained
—
Assigning Functions to Assignable Switches 147