Yamaha HTR-5063 Owner's Manual page 12

■
(U.S.A. and Canada models only)
Changing speaker impedance
This unit is configured for 8Ω speakers as the factory setting.
When connecting to 6Ω speakers, carry out the following
procedure to switch to 6Ω.
Switch this unit to the standby mode.
1
Press A while pressing and holding STRAIGHT on
2
the front panel.
Release the keys when "ADVANCED SETUP" is displayed on
the front panel display.
After approximately a few seconds, the top menu items are
J1
displayed.
A PROGRAM l / h
YPAO MIC
INFO MEMORY PRESET
BD
DVD
PHONES INPUT TONE CONTROL
SILENT CINEMA
Check that "SP IMP." is displayed on the front panel.
3
SP IMP. -8 MIN
J J
1 : Refer to the "Extended functionality that can be configured as needed
(Advanced Setup menu)" (☞p. 66) for details on the Advanced Setup menu.
Press STRAIGHT repeatedly to select a "6ΩMIN."
4
5 Switch this unit to the standby mode, and then
switch it on again.
The power turns on, when the settings you made has been
configured.
■
Connecting speakers
2 2
FM AM
1 Remove approximately 10 mm of insulation from the
SCENE
TV CD RADIO ends of the speaker cables, and twist the bare wires
PROGRAM STRAIGHT
of the cables together firmly so that they will not
cause short circuits.
STRAIGHT
Loosen the speaker terminals.
2
3 Insert the bare wire of the speaker cable into the gap
on the side of the terminal.
Tighten the terminal.
4
3
F R
O N
T
1
4 4
CONNECTIONS
Connecting speakers
Connecting the banana plug (Except U.K., Europe,
Asia and Korea models)
Tighten the knob, and then insert the banana plug into the end of
the terminal.
Banana plug
F R
O N
T
12
En