To Replace The Power Cord - Dimplex Multifire DF3015 Parts And Service Manual

DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE THE POWER CORD

1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Remove the 6 retaining screws and drill out any rivets holding the top cover to
the fireplace.
5. Lift the top cover being careful not to damage any of the wiring
6. Disconnect the power cord wires from the circuit board.
7. With needle nose pliers grasp the power cord strain relief grommet from inside
the rear panel and push while twisting to remove.
8. Pull the power cord out through the hole in the rear cover.
9. Install the new cord set through the hole in the rear cover by placing the strain
relief over the cord, hold the strain relief with pliers and slide into mounting hole.
10. Connect all of the wiring connections in their original locations on the terminal
block.
11. Reassemble in the reverse order as above.
15