To Replace The Power Cord - Dimplex SF55992-AU Parts And Service Manual

If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE THE POWER CORD

1. Remove the firebox trim by placing your hand on the grill section, grasping the
trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing it
upside down on the top of the unit being careful not to damage any of the wiring.
5. Locate and disconnect the power cord wire connections from tri-clamp noting
their original locations.
6. Release tri-clamp from power cord and remove power cord.
7. Install power cord through tri-clamp and secure tri-clamp to power cord.
8. Reassemble in the reverse order as above.
17