To Replace Heater Assembly - Dimplex Multifire DF3015 Parts And Service Manual

DF3015
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE HEATER ASSEMBLY

1. Slide fireplace out of mantel 2-3 inches.
2. Remove 4 Phillips screws from the right side of trim.
3. Slide glass to right side of fireplace to remove.
4. Remove the 6 retaining screws and drill out any rivets holding the top cover to the
fireplace.
5. Lift the top cover being careful not to damage any of the wiring.
6. Remove the 4 heater retaining screws from the top of the cover.
7. Disconnect the heater wiring connector from the circuit board.
8. Remove the 2 heater mounting brackets from the old heater and install them on the new
heater.
9. Reassemble in the reverse order as above.
13