To Replace The Power Cord - Dimplex DFB4047 Parts And Service Manual

DFB4047
If unit was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE THE POWER CORD

1. Open the front control cover.
2. Remove front glass by removing the 2 outer screws holding the class clips.
3. Remove the log grate by removing the 4 mounting screws.
4. Remove the log set by lifting straight up.
5. Lay the insert on it's back and remove the 2 switch control cover screws located on the
bottom of the insert.
6. Disconnect the power cord wires from the terminal block
7. With needle nose pliers grasp the power cord strain relief grommet from inside the rear
panel and push while twisting to remove.
8. Pull the power cord out through the hole in the rear cover.
9. Install the new cord set through the hole in the rear cover by placing the strain relief
over the cord, hold the strain relief with pliers and slide into mounting hole.
10. Connect all of the wiring connections in their original locations on the terminal block.
11. Reassemble in the reverse order as above.
12