Paper Jam In The Reversing Automatic Document Feeder (Lower) - Toshiba E-Studio 5540c Troubleshooting Manual

1 TROUBLESHOOTING FOR THE HARDWARE
Do not touch the fuser unit or the metal portion around it.
Do not touch the fuser or the metal portion around it when you remove the
jammed paper from the fuser unit. This could burn you or the shock could
cause you to injure your hand in the machine.
Do not touch the transfer belt.
Do not touch the transfer belt when you remove the jammed paper inside
the right side of the equipment. Doing so may damage to the equipment or
result in a poor output.
If paper jams occur frequently
The following are the common causes of paper jams. If the problem persists, check for the following situations.
An unsuitable original is placed on the Reversing Automatic Document Feeder.
Paper unsuitable for the equipment is used.
Paper sizes are not consistent between the size in a drawer or the bypass tray and the size registered in the
equipment.
All the jammed paper has not been removed.
There is too much of a gap between the paper and the side or end guide in the drawer.
The amount of paper placed in a drawer exceeds the limit indicated on its side guide.

Paper jam in the Reversing Automatic Document Feeder (lower)

1
Open the Reversing Automatic Document Feeder.
2
Push the green lever, open the reverse cover and
remove the original.
16 Clearing a Paper Jam