Toshiba E-Studio 5540c Troubleshooting Manual page 36

1 TROUBLESHOOTING FOR THE HARDWARE
Receiving tray lower cover
1
Separate the finisher from the equipment when it is installed.
1) Open the front cover of the finisher when the Hole Punch Unit is not installed. Open the Hole Punch Unit cover
when the Hole Punch Unit is installed.
2) Pull the lever to unlock the finisher.
When the Hole Punch Unit is not installed
3) Move the finisher until it stops placing your hands on the positions shown in the figure.
When the Hole Punch Unit is not installed
2
Using the handle under the receiving tray, open the
cover and remove the paper.
3
Close the cover under the receiving tray.
4
Close the covers of the finisher and the Hole Punch
Unit (when it is installed) first, and connect the
finisher to the equipment.
Move the finisher slowly placing your hands on the positions shown
in the figure.
Be careful not to let your fingers be caught between the
finisher and the equipment
34 Clearing a Paper Jam
1
2
When the Hole Punch Unit is installed
1
When the Hole Punch Unit is installed
2