Paper Jam In The Reversing Automatic Document Feeder (Lower) - Toshiba E-STUDIO 555 Troubleshooting Manual

1.TROUBLESHOOTING FOR THE HARDWARE
Do not touch the transfer belt.
Do not touch the transfer belt when you removing the paper jammed inside
the equipment. Doing so may cause damage on the equipment or result in a
poor output.
If paper jams occur frequently
The following are the common causes of paper jams. If the problem persists, check for the following situations.
An unsuitable original is placed on the Reversing Automatic Document Feeder.
Unavailable paper with the equipment is used.
Paper sizes are not consistent between the size in a drawer or the bypass tray and the size registered in the
equipment.
All the jammed paper has not been removed.
There is too little or too much of a gap between the paper and the side guide in the drawer.
The amount of paper placed in a drawer exceeds the limit indicated on the side guide of the drawer.

Paper jam in the Reversing Automatic Document Feeder (Lower)

1
Open the Reversing Automatic Document Feeder.
2
Open the reverse cover and remove the original.
3
Close the reverse cover.
1 TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 13