Table of Contents
Advertisement
Step 2: Prepare the Installation Site
ATTENTION:
•
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués par le personnel autorisé uniquement.
•
If the EBP will be installed into fine furniture, it is best to hire a licenced, bonded craftsperson to cut the access hole
and perform the physical installation so the surface will not be damaged.
•
S'il est prévu d'installer le EBP dans du beau mobilier, il est préférable de faire appel à un artisan autorisé et qualifié
pour couper le trou d'accès et réaliser l'installation de telle façon que la surface ne soit pas endommagée.
•
Follow all national and local building and electrical codes that apply to the installation site.
•
Respectez tous les codes électriques et du bâtiment, nationaux et locaux, qui s'appliquent au site de l'installation.
Americans with Disabilities Act (ADA) compliance
When planning where to install these devices, you may need to consider factors affecting accessibility of the button panel such
as height from the floor, distance from obstructions, and how far a user must reach to press the buttons. For guidelines, see
sections 307 ("Protruding Objects") and 308 ("Reach Ranges") of the 2010 ADA Standards for Accessible Design available at
http://www.ada.gov/regs2010/2010ADAStandards/2010ADAStandards.pdf.
Step 3: Change Button Labels or Knob
You can replace button labels or the volume control knob. Some button labels ship with the unit. You can create and print your
own customized labels using Extron Button Label Generator software.
Changing the button labels
Remove the four Phillips-head screws holding the
1.
faceplate to the unit (see
page) and remove the faceplate.
Gently separate the button lens cap from its white diffuser,
2.
insert the end of the provided Extron removal tool into the
corner notch, and gently twist the tool (see figure 3,
Remove the label insert from the button cap.
3.
TIP: If the insert does not come out easily, use a piece
of sticky tape to pull it out of the button cap.
Select one of the button labels from the printed label
4.
sheets included with the unit. Remove the label from its
backing and remove the clear, protective film from the
other side of the label.
Insert the button label into the button cap (
5.
Align the cap with the white diffuser and the panel
6.
opening, and press the clear cap into place on the button.
Attach the faceplate to the EBP by aligning the openings
7.
of the faceplate with the buttons, the knob, and the LEDs
and place the faceplate against the unit.
Secure the faceplate to the unit using the four
8.
Phillips-head screws removed in step 1.
figure
2,
D
, on the previous
1
2
).
).
1
Separate the
two-piece button
here at the corner.
Replacing Buttons
Figure 3.
Product Category
T E
X T
Base
Diffuser
2
Insert
button label.
Button
Lens Cap
Removal
Tool
3
Advertisement
Table of Contents
